Store program
The
Store program
function allows to memorize the actual labeller and labelling para-
meters under a program number. 32 memory locations or program numbers are
available. The actual program number is indicated as proposal. It can be overwritten or
changed on the keyboard. Before memorizing a safety inquiry prevents a program to be
overwritten by mistake. Entering can be aborted by the
ESC
key.
By depressing the
ENTER
key, the data are memorized under the entered program number.
STORE PROGRAM
PROGRAM 10
owerwrite ?
as number 10
break [ESC]
execute [ENTER]
User level:
programmer
Operating mode:
STOP
Program name
The
Program name
function is used to file a descriptive designation or an identification
under a labelling program. The program name is entered with the numerical keyboard
and terminated with the
ENTER
key. The figures
0...9
as well as the capital letters from
A....Z
and some special characters can be entered. When entering a character always
start with a figure from 0...9. If a letter should be entered, the figure can be modified by
the
UP
and
DOWN
keys until the wanted letter appears. The next number has to begin
again with entering a figure. After having finished, terminate the function with the
ESC
key. The length of the
program name is limited to 7 characters.
Example:
To enter the letter
A
proceed as follows:
Enter
1
. Then increase the figure with the
UP
key until the letter
A
appears, then relea-
se the key.
In this way all seven digits can be entered one after the other.
PROGRAM NAME
Choice: TEST123
programmer
STOP
User level:
Operating mode:
5999.530-01B 13.08.98 WM
Page 25 /
49
