Position
The
Position
function is used to set a speed dependent labelling delay. This delay
2
causes a speed-independent positioning of the label
3
on the good
5
in feed direction
4
.
With this function it is not necessary to shift the goods scanner
1
to obtain a change of
the label position on the goods.
POSITION
Value : 10 mm
Note:
If the value of the position adjustment exceeds the goods distance, a
malfunction will occur, because not each good is labelled.
Predispensing and position influence the placement of the label on the
goods. For a good result, first adjust the predispensing and then the
position of the labels. (If afterwards the predispensing is changed, the
position of the goods will also be changed.)
Attention:
Die position setting must not be used to compensate long distances.
Otherwise goods will not be labeled correctly if the goods distance is
shorter than the position setting.
The position value is speed-independent. If with high speed the calcula-
ted position value is too small this will be indicated as an error. See
diagram 'Position' in the Technical Appendix.
1
2
3
4
5
programmer/operator
RUN/STOP
User level:
Operating mode:
5999.530-01B 13.08.98 WM
Page 19 /
49
