CleaverBrooks ADAC 1000, Operation Manual

Page: 105 / 140

APPENDIX A - Variable Frequency Drive Parameters
Part No. 750-386 A-11
* A163 Auto Restart Tries 0 1
* A164 Auto Restart Delay 1.0 Secs 5.0 (5 sec)
* A165 Start At Power Up Disabled Enabled, 001
A166 Reverse Disable Rev Disabled OK
A167 Flying Start Enable Disabled OK
A168 PWM Frequency 4.0 kHz OK
A169 PWM Mode 2-Phase OK
A170 Boost Select 45.0, VT OK
A171 Start Boost 2.5% OK
A172 Break Voltage 25.0% OK
A173 Break Frequency 15.0 Hz OK
A174 Maximum Voltage Rated Volts OK
A175 Slip Hertz @ FLA 2.0 Hz OK
A176 DC Brake Time 0.0 Secs OK
A177 DC Brake Level Rated Amps x 0.05 OK
A178 DC Brk Time @Strt 0.0 Secs OK
A179 Current Limit 1 Rated Amps x 1.1 OK
A180 Current Limit 2 Rated Amps x 1.1 OK
A181 Motor OL Select No Derate OK
A182 Drive OL Mode Both-PWM 1st OK
A183 SW Current Trip 0.0 Disabled OK
A184 Load Loss Level 0.0 Disabled OK
A185 Load Loss Time 0 Secs OK
A186 Stall Fault Time 60 Seconds OK
A187 Bus Reg Mode Enabled OK
A188 Skip Frequency 1 0 Hz OK
A189 Skip Freq Band 1 0.0 Hz OK
A190 Skip Frequency 2 0 Hz OK
A191 Skip Freq Band 2 0.0 Hz OK
A192 Skip Frequency 3 0 Hz OK
A193 Skip Freq Band 3 0.0 Hz OK
A194 Compensation Electrical OK
A195 Reset Meters Ready/Idle OK
A196 Testpoint Select 1024 OK
A197 Fault Clear Ready/Idle OK
A198 Program Lock Unlocked OK
A199 Motor NP Poles 4 OK
* A200 Motor NP Amps Drive Rated Amps Per Motor Nameplate
A201 PID Invert Error Not Inverted OK
A202 MOP Reset Sel Save MOP Ref OK
Advanced Display
d301 Control Source Read Only
d302 Contrl In Status Read Only
d303 Comm Status Read Only
d304 PID Setpnt Displ 0.0%
d305 Analog In 1 0.0%
d306 Analog In 2 0.0%
d307 Fault 1 Code Read Only
d308 Fault 2 Code Read Only
d309 Fault 3 Code Read Only
d310 Fault 1 Time-hr Read Only
d311 Fault 1 Time-min Read Only
d312 Fault 2 Time-hr Read Only
d313 Fault 2 Time-min Read Only
d314 Fault 3 Time-hr Read Only
d315 Fault 3 Time-min Read Only