Clear-Com CELLCOM 10, Instruction Manual

Page: 147 / 168

Vitec Group Communications
CellCom-10 Instruction Manual 1 1 - 7
serial cable from the beltpack – it will automatically detect when a
new beltpack is connected.
• Power cycle the base station and the beltpacks, and check that
they communicate successfully with each other.
CELLCOM CONFIGURATION CONTROLLER
The Configuration Controller allows the user to back up and restore
configurations that have been made on the base station front panel to
a PC. It can also be used to “clone” the configuration of one base
station onto another, but be aware that the configuration includes
beltpack registrations and the system ID, so beltpacks will be
registered to both base stations, which can cause conflicts.
It connects to the base unit using a crossover (Null-Modem) serial
cable plugged into the “PC PROGRAM” port. If this cable was not
shipped with the Cellcom unit, the pinout is described in Figure 11-1.
The maps generated by the Configuration Controller are compatible
with those generated by the Configuration Editor (see chapter
“CellCom 10 Configuration Editor”.
SELECTING THE PC COM PORT
Use the COM port drop-down box to select the COM port that the
serial cable is plugged into on the PC. Click on the arrows next to the
dropdown to select the required port.
Figure 11-9: Select PC COM Port
BACKING UP A CONFIGURATION FROM THE BASE
STATION
Click the “Receive” button.