Clear-Com CELLCOM 10, Instruction Manual

Page: 33 / 168

Vitec Group Communications
CellCom-10 Instruction Manual 2 - 7
the 4-wire device should be able to hear audio from the wireless
beltpack.
• Examine wireless beltpack #2 . If it is on page #1, the green
(listen) light should be flashing and it should be possible to hear
audio from beltpack #1. At this point, beltpack #1 won’t be able to
hear audio from beltpack #2.
3. Press the leftmost rotary knob on beltpack #2, which is next to the
flashing green light.
All stations are able to hear beltpack #2 as well as beltpack #1. In
other words, all stations can hear each other.
4. Press the leftmost rotary controllers on beltpacks #1 and #2 briefly
to unlatch them. This deactivates all talk and listen paths.
CALLING THE GROUP FROM THE 4-WIRE
AUDIO DEVICE
1. From the base station’s front-panel menu, select PORTS, then
4WIR1, then CALLS, then GP#01.
The changes are saved and applied automatically five seconds after
the last time the setup/enter knob is pressed or turned. The
front-panel display flashes to indicate that the changes are being
saved and applied.
• All stations should now be able to hear the audio coming in from
the 4-wire device.
• On the two wireless beltpacks, the green (listen) lights should be
flashing, indicating an incoming call to group #1 from a member of
group #1.
2. Note that if the base station is power cycled off and on again, the
talk paths from the 4-wire device are automatically re-established to
the wired beltpack and to the two wireless beltpacks.
3. It is possible to remove the talk paths from the 4-wire device to the
wired beltpack and to the two wireless beltpacks by selecting
PORTS, then 4WIR1, then CALLS, then NONE, from the base
station’s front-panel menu.
4. Note that if the calling 4-wire port is included in the group that is
being called from the 4-wire device the 4-wire audio will not be
looped back to itself.
CALLING THE GROUP FROM THE WIRED
PARTY-LINE BELTPACK
1. From the base station’s front-panel menu, select PORTS, then
PLCHA, then CALLS, then GP#01.
The changes are saved and applied automatically five seconds after
the last time the setup/enter knob is pressed or turned. The