Clear-Com CELLCOM 10, Instruction Manual

Page: 36 / 168

Vitec Group Communications
CellCom-10 Instruction Manual
3 - 2
Headset Connector
The 4-pin male XLR-type headset socket connects to Clear-Com
headsets and other headsets with 4-pin female connectors. This
headset connector is for the onboard two-channel intercom, with
controls just to the right of the connector.
Channel A Talk Switch and Light/Listen Level
Knob
The channel A talk switch and associated light, and listen level knob,
allow full-duplex conversations with any CellCom 10 wireless
beltpacks or other communications systems wired to the rear of the
base station to which the onboard Channel A has been assigned.
Assignments are done via the front-panel programming.
The talk switch is momentary/latching, such that pressing it and
holding down will create a talk path that ends when the user releases
the switch, while quickly tapping it will latch the talk, and a second tap
will release it. The LED lights red when a talk is active.
Turning the listen level knob clockwise will allow the user to hear the
other party’s voice, increasing the level to maximum when fully
clockwise.
A/B Reply Button
Pressing this button will reply to the last caller to call A or B.
Channel B Talk Switch and Light/Listen Level
Knob
The channel B talk switch and associated light, and listen level knob,
function the same as the controls for Channel A.
Party Line Channels A and B Enable Switches
The channel A and channel B enable switches and associated lights
activates the power on the rear-panel to party-line intercom channels A
and B. Activating one or both of these switches enables the power to
that party line. These switches may be “locked” via the front-panel
SYSTEM programming menu so that they may not be disengaged
accidentally.
If the button is held in for more than 8 seconds autonulling mode will be
enabled for the current party line and the following message will be
displayed:
“Release button to begin autonulling”
1
2
3
4
5