Clear-Com CELLCOM 10, Instruction Manual

Page: 130 / 168

Vitec Group Communications
CellCom-10 Instruction Manual
1 0 - 2
At this point the user has the choice of either loading a previously
extracted configuration from disk, or extracting one from a
Cellcom/Freespeak base unit.
LOADING A CONFIGURATION FROM DISK
To load a configuration from disk, click the "Load" button. A dialog box
will pop up, allowing the user to browse for the configuration file.
Configuration files end in a ".map" extension.
Figure 10-2: Map Select Screen
COM PORT SELECTION
The COM port drop-down box shows only those ports that are
available for connection to the base unit. If the required port is not
shown it may be that another program is using this port. Close the
other program down, and try again.
RETRIEVING A CONFIGURATION FROM A CELLCOM
10 BASE UNIT
• Connect the PC to the base using a standard Cellcom/Freespeak
serial cable. Select the COM port that it is connected to using the
drop-down box in the "Serial comms" section of the dialog. Power
on the Cellcom/Freespeak base unit and wait 30 seconds.
• Click the "Retrieve" button in the "Serial Comms" section of the
dialog. Retrieval of the configuration should take around 1 min 15
secs. If the program fails to connect to the Cellcom/Freespeak
base, the following dialog will be displayed: