Clear-Com CELLCOM 10, Instruction Manual

Page: 146 / 168

Vitec Group Communications
CellCom-10 Instruction Manual
1 1 - 6
• Run the beltpack registration application, and select the COM port
that the serial cable is attached to on the PC. If the beltpack
communicates correctly with the PC, after a few seconds the
application should produce a display similar to this:
Figure 11-7: Base Station ID
• The beltpack serial number is also displayed as a read-only value
– this can be useful if the sticker on the back of the beltpack is
missing or damaged.
• If the communication is not successful, the system ID and serial
number will remain as dashes:
Figure 11-8: Communication Failure
• In this case check the cable and COM port.
• On the Cellcom base station, select “SYSTEM->INFO”. Along with
the firmware version number and the IP address, the System ID
should be displayed as a 7 character alphanumeric value. Enter
this number into the System ID box of the PC beltpack registration
application, and press the Program button. The application will
automatically read back the value stored in the beltpack to check
that it has been written correctly.
• Repeat the process for all the beltpacks to be registered. There is
no need to exit the registration application before removing the