Clear-Com CELLCOM 10, Instruction Manual

Page: 46 / 168

Vitec Group Communications
CellCom-10 Instruction Manual
4 - 8
Figure 4-2: 4-Wire RJ-45 Pinout
CONNECTING TO CLEAR-COM MATRIX PLUS
The connection between a Matrix Plus digital intercom port and a
CellCom 10 4-wire port is accomplished with a standard 4-pair CAT-5
data cable with RJ-45 connectors on both ends. In the current
generation of CellCom 10, the audio input and audio output pairs are
all that will be used.
In the Matrix Plus PGM-WIN configuration software, set the matrix port
that is connected to the CEL-BASE base station 4-wire port to
“4-Wire.” If the label of this CellCom 10 4-wire port is to be put onto
more than one intercom panel within the matrix system, and any and
RJ-45 CONNECTOR
AT BASE STATION PORT
RJ-45 PINOUT ON
4-WIRE EQUIPMENT
Base Station RJ-45 Pin Numbers
Shielded category-5 cables wired pin-to-pin
4-Wire Pin Numbers
Pair 2
Pair 1
Pair 3
Pair 4
Not Used
Not Used
Audio Input +
(into Base Station)
Audio
(from Base Station
)
Audio Output –
(from Base Station)
Audio Input –
(into Base Station)
Not Used
Not Used
1
2
3
5
6
7
1
2
6
7
8
4
3
4
5
8
Not Used
Not used
Audio
Audio Input +
Audio Input –
Audio Output –
Not Used
Not Used
Pair 1
Audio output from Base Station to 4-Wire
Pair 2
Not used
Pair 3
Audio input from 4-Wire to Base Station
Pair 4
Not used
8 7 6 5 4 3 2 1
8 7 6 5 4 3 2 1
Views from
front of
connectors