Clear-Com CELLCOM 10, Instruction Manual

Page: 150 / 168

Vitec Group Communications
CellCom-10 Instruction Manual
1 1 - 1 0
If it does communicate with the base station successfully, the status
text will change to “Send in progress”, and the progress bar will begin
to advance.
Figure 11-15: Save New Configuration
When the send is complete, the status text should change to
“Completed OK”, and the base station will reboot after a few seconds.
SERIAL UPGRADER
This application is used to upgrade the firmware of the Cellcom base
unit when a new version is released.
It connects to the base unit using a crossover (Null-Modem) serial
cable plugged into the “PC PROGRAM” port. If this cable was not
shipped with the Cellcom unit, the pinout is described in Figure 11-1. It
expects to be connected to COM port 1 of the PC.
UPGRADING THE BASE UNIT FIRMWARE
On launching the application a dialog box like this should appear.
Figure 11-16: Upgrading Base Unit Firmware