Clock Commands
78-20269-01 Command Line Interface Reference Guide
108
6
Syntax
sntp server {
ipv4-address
|
ipv6-address
|
ipv6z-address
|
hostname
} [
poll
] [
key
keyid
]
no sntp server {
ipv4-address
|
ipv6-address
|
ipv6z-address
|
hostname
}
Parameters
•
ipv4-address—Specifies the server IPv4 address.
•
ipv6-address—Specifies the server IPv6 address. A Link Local address
(IPv6Z address) can be defined.
•
pv6z-address
—
Specifies the IPv6Z address to ping. The IPv6Z address
format is:
ipv6-link-local-address
}%{
interface-name
}. The subparameters
are:
-
ipv6-link-local-address—Specifies the IPv6 Link Local address.
-
interface-name—Specifies the outgoing interface name. The interface
name has the format:
vlan
{
integer
} |
po
{
integer
} |
isatap
{
integer
} |
{
physical-port-name
}. The subparameter integer has the format:
{
decimal-digit
} | {
integer
}{
decimal-digit
}. (Range for the decimal-digit:
0–9)
The following combinations are possible:
-
ipv6_address%interface_id - Refers to the IPv6 address on the interface
specified.
-
ipv6_address%0 - Refers to the IPv6 address on the single interface on
which an IPv6 address is defined.
-
ipv6_address - Refers to the IPv6 address on the single interface on
which an IPv6 address is defined.
•
hostname—Specifies the server hostname. Only translation to IPv4
addresses is supported. (Length: 1–158 characters. Maximum label length:
63 characters)
•
poll—Enables polling.
•
key keyid—Specifies the Authentication key to use when sending packets
to this peer. (Range:1–4294967295)
Default Configuration
No servers are defined.
