Cisco ONS 15454, Hardware Installation Manual

Page: 497 / 516

A P P E N D I X
A
Hardware Specifications
This appendix contains hardware and software specifications of the ONS 15454 (ANSI and ETSI), ONS
15454 M2, and ONS 15454 M6 shelf.
Unless otherwise specified, “ONS 15454” refers to both ANSI and ETSI M12 shelf assemblies.
Note
Unless otherwise specified, the ECU module refers to the ECU, ECU2, and ECU-60V units. For details about
the various ECU modules, see the
External Connection Units, on page 342 .
Note
Due to memory limitations, TCC2/TCC2P cards are not supported as the node controller in multi-shelf
configuration from R10.5.2.6. Hence, it is recommended to use TCC3 card as the node controller in multi-shelf
configuration. The TCC2P card can be used as a control card in a subtended shelf where the node controller
is TCC3 card on ONS 15454 chassis or TNC/TNCE/TNCS/TNCS-O cards on ONS 15454 M6 or NCS 20015
chassis. The TCC2P card can also be used as a node controller in a stand-alone configuration.
Note
The following sections are included:
• ONS 15454 Shelf Specifications, on page 467
• ONS 15454 M2 Shelf Specifications, on page 471
• ONS 15454 M6 Shelf Specifications, on page 474
ONS 15454 Shelf Specifications
This section provides specifications for shelf bandwidth; a list of topologies; Cisco Transport Controller (CTC)
specifications; the LAN, Transaction Language One (TL1), modem, and alarm specifications; timing, power,
and environmental specifications; and shelf dimensions.
Bandwidth
The ONS 15454 has these bandwidth specifications:
Cisco ONS 15454 Hardware Installation Guide
467