Cisco ONS 15454, Hardware Installation Manual

Page: 136 / 516

Table 17: LAN Pin Assignments
Function RJ-45 Pin RJ-45 Pin LAN
white/green 3 1 LAN 1 Connecting to
DCE
2
(a hub or
switch)Cross-over
Ethernet cable
PNMSRX–green 6 2
PNMSTXwhite/orange 1 3
— 4 4
— 5 5
PNMSTX–orange 2 6
— 7 7
— 8 8
white/green
1 1 LAN 1Connecting to
DTE(a
PC/workstation or
router)Straight-through
Ethernet cable
PNMSRX–green 2 2
white/orange 3 3
— 4 4
— 5 5
PNMSTX–orange 6 6
— 7 7
— 8 8
2
The Cisco ONS 15454 ETSI is DCE.
Step 2 Return to your originating procedure (NTP).
DLP-G23 Install Alarm Wires on the Backplane (ANSI Only)
This task installs alarm wires on the backplane so that you can provision external
(environmental) alarms and controls with the AIC-I card. If you are using the
AEP, do not perform this task. Purpose
Wire wrapper
#22 or #24 AWG (0.51 mm² or 0.64 mm²) wires
100-ohm shielded BITS clock cable pair #22 or #24 AWG (0.51 mm² or 0.64
mm²), twisted-pair T1-type
Tools/Equipment
NTP-G5 Remove the Backplane Covers (ANSI Only), on page 63
Prerequisite Procedures
Cisco ONS 15454 Hardware Installation Guide
106
Installing the ONS 15454 M12 (ANSI and ETSI) Shelf
DLP-G23 Install Alarm Wires on the Backplane (ANSI Only)