Cisco ONS 15454, Hardware Installation Manual

Page: 390 / 516

Always use the supplied ESD wristband when working with a powered ONS 15454 M6. For detailed instructions
on how to wear the ESD wristband, see the
Electrostatic Discharge and Grounding Guide for Cisco CPT and
Cisco ONS Platforms .
Caution
Procedure
Step 1
Disconnect the power source and remove the power connections from the B-side power module (installed in
slot B).
Step 2 Unscrew the holding screw that secures the 15454-M6-AC2 power module.
Step 3 Pull the 15454-M6-AC2 power module clear from the ONS 15454 M6 chassis.
Step 4
Install the 15454-M6-AC power module as described in the DLP-G569 Install the AC Power Module in the
ONS 15454 M6 Shelf, on page 355 .
Step 5 Install power on the 15454-M6-AC power module as described in the NTP-G256 Install Power and Ground
to the ONS 15454 M6 Shelf , on page 370 .
While replacing the power modules, do not provision or install any line cards when the ONS 15454
M6 chassis is in the mixed power mode (with both 15454-M6-AC and 15454-M6-AC2 power
modules installed). Card provisioning and installation must be done only after both the slots have
the same type of power modules.
Note
Step 6 Perform steps 1 to 5 for the other power module (installed in slot A).
Step 7
Return to your originating procedure (NTP).
DLP-G570 Install the DC Power Module in the ONS 15454 M6 Shelf
This procedure installs the 15454-M6-DC, 15454-M6-DC20, or 15454-M6-DC40
DC power module in the ONS 15454 M6 system. Purpose
#2 Phillips Dynamometric screwdriver
Tools/Equipment
• NTP-G252 Install the ONS 15454 M6 Shelf , on page 294 .
• NTP-G259 Open and Remove the Standard Door of the ONS 15454 M6
Shelf , on page 327
.
• Connect the chassis to the office ground. For detailed instructions on how
to ground the chassis, see the Electrostatic Discharge and Grounding Guide
for Cisco CPT and Cisco ONS Platforms .
Prerequisite Procedures
Required Required/As Needed
Onsite Onsite/Remote
None
Security Level
Cisco ONS 15454 Hardware Installation Guide
360
Installing the ONS 15454 M6 Shelf
DLP-G570 Install the DC Power Module in the ONS 15454 M6 Shelf