Cisco ONS 15454, Hardware Installation Manual

Page: 131 / 516

• Complete the DLP-G24 Install Timing Wires on the Backplane (ANSI Only), on page 109 if you are
provisioning external timing.
• Complete the DLP-G25 Install LAN Wires on the Backplane (ANSI Only), on page 110 to create an
external LAN connection. You must either install LAN wires on the backplane or connect a CAT-5
Ethernet cable to the LAN port on the TCC2/TCC2P/TCC3 card to create an external LAN connection.
• Complete the TL1 Craft Interface Installation, on page 99 to access Transaction Language One (TL1)
using the craft interface. Craft wires or the EIA/TIA-232 port on the TCC2/TCC2P/TCC3 card are
required to access TL1.
Stop. You have completed this procedure.
DLP-G20 Install Alarm Wires on the MIC-A/P (ETSI Only)
This task installs alarm cables on the MIC-A/P on the ONS 15454 ETSI so that
you can provision external (environmental) alarms and controls with the AIC-I
card. Purpose
DB-62 connector
0.51 mm² or 0.64 mm² (#22 or #24 AWG) wires
Tools/Equipment
NTP-G6 Install the MIC-A/P and MIC-T/C/P FMECs (ETSI Only), on page 66 Prerequisite Procedures
As needed Required/As Needed
Onsite Onsite/Remote
None
Security Level
Procedure
Step 1
Using 0.51 mm² or 0.64 mm² (#22 or #24 AWG) wires, connect the alarm and control wires on the appropriate
pins of the DB-62 connector. The pin connectors, signal names, and functions are listed in the following table.
Table 15: Alarm Pin Assignments
Function Signal Name DB-62 Pin Connector
Alarm cutoff ALMCUTOFF– 1
Alarm cutoff AL 2
Alarm input pair number 1 ALMINP0– 3
Alarm input pair number 1 4
Alarm input pair number 2 ALMINP1– 5
Cisco ONS 15454 Hardware Installation Guide
101
Installing the ONS 15454 M12 (ANSI and ETSI) Shelf
DLP-G20 Install Alarm Wires on the MIC-A/P (ETSI Only)