Cisco ONS 15454, Hardware Installation Manual

Page: 156 / 516

DLP-G371 Install the Ethernet Adapter Panel
This task installs an Ethernet adapter panel (EAP) in an ANSI or ETSI equipment
rack. The EAP is used in multishelf node configurations to connect the
MS-ISC-100T and the TCC2/TCC2P/TCC3 cards in the subtending nodes. Two
EAPs are required in a multishelf configuration, one for each MS-ISC-100T card. Purpose
#2 Phillips Dynamometric screwdriver Tools/Equipment
None Prerequisite Procedures
As needed Required/As Needed
Onsite Onsite/Remote
None
Security Level
Procedure
Step 1
The EAP requires 1 RU in a standard 19-inch (482.6-mm), 23-inch (584.2-mm)/600 mm x 600mm, or 600
mm x 300 mm rack. Locate the RMU space specified in your site plan.
Step 2 Verify that the mounting brackets attached to the unit are correct for your rack size. Complete the DLP-G3
Reverse the Mounting Bracket to Fit a 19-inch (482.6-mm) Rack (ANSI Only), on page 33 as required.
Step 3 Align the chassis with the rack mounting screw holes, insert the four screws, and tighten.
Any paint between the EAP mounting ears and the frame of the metal rack must be removed. The
area must then be cleaned and coated with an antioxidant. Caution
Step 4
Repeat Steps 1 to 3 for the second EAP.
Step 5 Return to your originating procedure (NTP).
DLP-G352 Install the Y-Cable Module Tray
This task installs the Y-cable tray. The Y-cable tray can store up to eight Y-cable
protection units. Purpose
#2 Phillips Dynamometric screwdriver
Y-cable module tray(s) (15454-YCBL-LC)
Cisco TransportPlanner Internal Connections Report
Tools/Equipment
None Prerequisite Procedures
As needed Required/As Needed
Onsite Onsite/Remote
None
Security Level
Cisco ONS 15454 Hardware Installation Guide
126
Installing the ONS 15454 M12 (ANSI and ETSI) Shelf
DLP-G371 Install the Ethernet Adapter Panel