Cisco ONS 15454, Hardware Installation Manual

Page: 171 / 516

Stop. You have completed this procedure.
NTP-G304 Configure the MS-ISC-100T Card for a ONS 15454
Multishelf Node for Non-Default Public and Private VLAN IDs
Use this procedure to configure the MS-ISC-100T Card for a multi-shelf node
for non-default public and private VLAN IDs. Purpose
Voltmeter Tools/Equipment
Applicable procedures in Installing the ONS 15454 M12 (ANSI and ETSI) Shelf,
on page 23
Prerequisite Procedures
Required Required/As Needed
Onsite Onsite/Remote
None
Security Level
Procedure
Step 1
At the Cisco IOS command line interface (CLI) for the MS-ISC-100T card, enter the following spanning tree
commands:
Example:
Router(config)#
bridge
public VLAN ID
protocol rstp
Router(config)#
bridge
public VLAN ID
forward-time 5
Router(config)#
bridge
public VLAN ID
max-age 10
Router(config)#
bridge
private VLAN ID
protocol rstp
Router(config)#
bridge
private VLAN ID
forward-time 5
Router(config)#
bridge
private VLAN ID
max-age 10
Step 2
Enter the following commands to configure the ports DCN 1 and DCN 2:
Example:
(Router(config)#
interface FastEthernet0
(Router(config-if)#
no ip address
(Router(config-if)#
no ip route-cache
(Router(config-if)#
bridge-group
public VLAN ID
(Router(config)#
interface FastEthernet1
(Router(config-if)#
no ip address
(Router(config-if)#
no ip route-cache
(Router(config-if)#
bridge-group
public VLAN ID
Cisco ONS 15454 Hardware Installation Guide
141
Installing the ONS 15454 M12 (ANSI and ETSI) Shelf
NTP-G304 Configure the MS-ISC-100T Card for a ONS 15454 Multishelf Node for Non-Default Public and Private VLAN IDs