19-16
Cisco ONS 15454 Procedure Guide, R5.0
September 2005
Chapter 19 DLPs A200 to A299
DLP-A222 Provision G-Series Ethernet Ports
DLP-A222 Provision G-Series Ethernet Ports
Step 1
In the node view, double-click the G-Series card graphic to open the card.
Step 2
Click the
Provisioning
>
Port
tabs.
Step 3
For each G-Series port, provision the following parameters:
•
Port Name—If you want to label the port, type the port name.
•
Admin State—Select the service state for the port. See the
“DLP-A214 Change the Service State for
for more information.
•
Auto Negotiation—Click this check box to enable autonegotiation on the port (default). If you do
not want to enable autonegotiation control, uncheck the box.
•
Flow Control—Click this check box to enable flow control on the port (default). If you do not want
to enable flow control, uncheck the box. To set custom flow control watermarks, see the
Provision G-Series Flow Control Watermarks” task on page 21-7
.
•
Max Size—To permit the acceptance of jumbo size Ethernet frames, choose
Jumbo
(default). If you
do not want to permit jumbo size Ethernet frames, choose
1548
.
Note
The maximum frame size of 1548 bytes enables the port to accept valid Ethernet frames that
use protocols, such as Inter-Switch Link (ISL). ISL adds 30 bytes of overhead and might
cause the frame size to exceed the traditional 1518 byte maximum.
Step 4
Payload Type—Click in the Payload Type field and select a cyclic redundancy check (CRC) size to set
the G-Series card’s LEX encapsulation:
•
LEX-FCS-16
is 16-bit (2 byte) CRC.
•
LEX-FCS-32
is 32-bit (4 byte) CRC.
Step 5
Click
Apply
.
Step 6
Refresh the Ethernet statistics:
a.
Click the
Performance > Statistics
tabs.
b.
Click
Refresh
.
Note
Reprovisioning an Ethernet port on the G-Series card does not reset the Ethernet statistics for
that port.
Step 7
Return to your originating procedure (NTP).
Purpose
This task provisions G-Series Ethernet ports to carry traffic.
Tools/Equipment
None
Prerequisite Procedures
DLP-A60 Log into CTC, page 17-66
Required/As Needed
As needed
Onsite/Remote
Onsite or remote
Security Level
Provisioning or higher
Summary of Contents for ONS 15454 Series
