Chino KP 2000 Series, Instructions Manual

Page: 98 / 144

- 95 -
10-11. External signal output
In case of specifications with external drive input, this controller can output externally the time signal and
various status signals by using open-collector signal. In 'External signal layout' of mode 11, terminal and
function of external signal output is allotted and used.
Function name Description
1. TS1
TS2
TS3
TS4
TS5
TS6
TS7
TS8
・
It is a time signal (continuous signal).
・
There are 8 types of time signals from TS 1 to TS 8. When time signal is ON
output signal is ON.
・
When program finished (END), output signal of time signals are all OFF.
2. RUN/STOP ・ It is the status signal of RUN/STOP (continuous signal).
・ When operation status is RUN output signal is ON and when it is STOP output
signal is OFF.
3. ADV
・
It is the status signal of ADV (momentary signal).
・
When operation status signal is ADV (Advance: Progress) output signal is ON
only for around 0.5 seconds.
4. RESET
・
It is the status signal of RESET (Continuous signal).
・
When operation status is RESET, output signal is ON.
5. WAIT
・
It is the status signal of WAIT (Continuous signal).
・
When operation status is WAIT, output signal is ON.
・
WAIT means waiting during real temperature compensation and in external
signal input the status is WAIT at the time of ON.
6. END
・
It is the status signal of END (Continuous).
・
When operation status is END (program end) output signal is ON.
*’ No setting condition ‘
－－－－－
’
is displayed when shipped form factory. If set any function once, not
setting condition is not displayed. Allocation setting is not initialized (no setting condition), even if
contents of settings are initialized.