Chino KP 2000 Series, Instructions Manual

Page: 39 / 144

- 36 -
6. Output limiter number and
output variation limiter number
[Output scaling specifications]
Ú
Option
①
Set output limiter number and output variation limiter number for
each pattern/step that is set.
②
Set anything from number 1 to 8 for both. Number 0 can also be set.
When 0 is set, it becomes a function that inherits the same step
number as that of the previous step.
③
In case of output scaling specification (special specifications), the
screen is, as shown on the lower left.
7.Output preset number
①
Set output preset number for every pattern/step.
②
Set from numbers 1 to 8. Number 0 can also be set. When 0 is set, it
becomes a function that inherits the same step number as that of
the previous step.
8.Sensor correction number
①
Set sensor correction number for every pattern/step.
②
Number 0 can also be set. When 0 is set, it becomes a function that
inherits the same step number as that of the previous step.
9. Time signal number
①
Only the specifications with external signal output (DO) are
displayed.
②
For every pattern/step that is set, time signal output destination and
time signal number to be used is set.
③
Set time signal output destination in 'TS' and time signal number in
'No.'.
④
Set time signal number from number 1 to 8, number 1R-8R, ON and
OFF. The 'R' after number is for repeating the time signal and only
during that step, is a function where in time signal of that number
repeats with identical setting value. 'ON' means everything ON and
'OFF' means everything OFF.
10. Real temperature
compensation number
①
Set real temperature compensation number for every pattern/step
that is set.
②
Set from number 1 to 8 and OFF. 'OFF' is a setting where in real
temperature compensation does not operate.
11. Waiting time alarm number
① Set waiting time alarm number for every pattern/step that is set.
② Number 0 can also be set. When 0 is set, it becomes a function that
inherits the same step number as that of the previous step.