S Layer 2 Managed Switch User Manual
陈泽科技有限公司
www.stephen-tele.com
87
Note
：
The IP address input above should be in the same IP network group range.
（
Here we suppose the IP of the switch is
192.168.1.254,
S
default IP is 192.168.1.254
）
Step 5
：
Click “OK” button, and return to the network connection property dialogue. Step 6 Click “OK” button uner the
networking property.
And then you can start to configure the switch through Telnet.
7
．
．
．
．
3 Connection
Click the “RUN” button at the “Start menu” on the desktop, input “cmd” in the
open dialogue window as below:
Figure 7-4 run
Click “OK”button
，
you can see the following dialogue window:
Figure 7-5 MS-DOS
Input “Telnet 192.168.1.254” at the dialogue window and click “enter” button, you will enter into the Telnet management
interface.
。
Figure7-6 Telnet management interface
