S Layer 2 Managed Switch User Manual
陈泽科技有限公司
www.stephen-tele.com
7
2.2.2 Specification
Model
S
Standards and Protocols
IEEE802.3
、
IEEE 802.3u
、
IEEE 802.3x
、
IEEE 802.3ab
、
IEEE 802.1Q
、
IEEE 802.1x
、
IEEE802.1D
Port No.
1000M
2
100M
24
SFP slot
2
Network Medium
10Base-T
：
UTP category 3 or above
；
100Base-TX
：
UTP category 5
；
1000Base-T
：
UTPcategory 5 or 6 or SFP port support single mode or multi-mode optical modules
MACAddress table
8K
Backboard bandwidth
8.8G
Filter and Transfer Rates
10Mbps: 14880pps; 100Mbps: 148800pps; 1000Mbps: 1488000pps
LED
Indicator
Link/Act
Light up/Blinks
100M
Light up
Other
Power
Dimension(L×W×H)
(mm)
440×205×44
Environment
Operating Temperature
：
0
℃
~40
℃；
Operating Humidity 10
％
~90
％
non-condensing;
Storage Temperature
：
-40
℃
~70
℃；
Storage Humidity 5
％
~90
％
non-condensing
Input
Input
：
180-240VAC
，
50-60Hz
；
Fig 2-1
S specification table
Chapter 3 Installation Guide
3.1 Installation
Follow these steps to install the switch:
The surface must support at least 5kg
The power source must be within 1.5m
Make sure the power cable has connected to the power socket in the back panel of the switch and the power supply
slot.
Make sure the switch is in a breezy environment and good for cooling the switch. Don’t put heavy things on the switch.
3.1.1 Hardware Installation on the desktop
1.Put the switch upside-down on a steady and big enough desk
2.Tear off the protective paste on the 4 pads, and paste them in the 4 circular slots in the underside of the switch.
3.Turn the switch over, and put it on the desktop.
