S Layer 2 Managed Switch User Manual
陈泽科技有限公司
www.stephen-tele.com
82
Trunk group enable and disable
disable or enable
Example
：
Switch(trunk 1)# enable
Trunk group member port flow control enable and disable
flow control <status>
Example
：
Switch(trunk 1)# flow control disable
Note
：
”enable” indicates open the flow control, ”disable” indicates close the flow control
Set Trunk group member ports list
member <ports list>
Example
：
Switch(trunk 1)# member 2-4
Note
：
trunk group 1 and trunk group 2 member port should be 2—24
，
port 1 can’t be a group port member
，
trunk group 3
should be gigabit ports. For Trunk group 1 and Trunk group 2 the ports number should be 2-8.
Set Trunk group routing mode
mode
<
mode
>
Example
：
Switch(trunk 1)# mode source
Note
：
There are three mode
，
”source”
，
”destination” and ” both’, source indicate using the source address of the data frame
for routing, ”destionation” indicate using the destination address of the data frame for routing,
，
”both” indicate using both
the source address and destination address of the data frame for routing,
Set Trunk group member port 802.1P default priority
priority <rate>
Example
：
Switch(trunk 1)# priority 2
Note
：
the rate should be within 0—7
Set Trunk group member default VLAN TAG
pvid <VLAN ID>
Example
：
Switch(trunk 1)# pvid 2
Note
：
VLAN ID should be within 1-4094
Set Trunk group member port operation method
speed <
operation method
>
Example
：
Switch(trunk 1)# speed full-100
Note
：
Set Trunk group member port operation method, for 10/100M and 10/100/1000M ports are different
10/100M ports
：
auto negotiate half-10 full-10 half-100 full-100
10/100/1000M ports
：
auto negotiate half-10 full-10 half-100 full-100 full-1000
Set Trunk group member port broadcasting strom control
storm control
Example
：
Switch(trunk 1)# storm control
BroadCast Suppress: enable
Multicast Suppress : enable
DLF Suppress : enable
packet percent: 20
