S Layer 2 Managed Switch User Manual
陈泽科技有限公司
www.stephen-tele.com
53
Set if the the port to valid STP computing.
Priority: value when the port in STP computing, which combine with Path Cost to indicate the port’s priority.
Path Cost: consumption from one port to another port, corresponds to port speed. It’s 100 for 100M port, and 4 for
1000M port.
5.3.8 SNMP
Configuration
SNMP
Configuration including SNMP Community and TRAP Target Configuration.
5.3.8.1
SNMP Community
Figure 5-43
SNMP Community
Entry: the switch support many Community, the entry to indicate certain one.
Community name
:the name of newly created entry, is one string with 1 to 20 English characters.
Read & Write popedom
: which SNMP Community empowers to end user.
Status
: whether the SNMP Community is activated to use.
5.3.8.2 SNMP TRAP Target Configuration
Figure 5-44
TRAP Target Configuration
Entry: the switch support many trap’s destination IP addresses, the entry to indicate certain one.
Name:
trap netry’s name, can configure freely.
Transport IP address
: the destination IP address to which TRAP forwards packets, usually is the IP address of the host where
the SNMP manager resides.
Transport port address:
the number of the port which forwards TRAP packets.
Timeout:
the overtime occurs in forwarding TRAP, it will reforward packets after overtime.
5.3.9 Authentication and Account Configuration
Authentication and Account Configuration including 802.1x Configuration
、
802.1x Port Configuration
、
802.1x User State
、Ｒ
adius Configuration
、
802.1x Transparent Configuration.
