S Layer 2 Managed Switch User Manual
陈泽科技有限公司
www.stephen-tele.com
70
Port : 1
ifIndex : 0x2100001
Admin State : Enable
Set Speed : autonegotiate
Actual Speed : unknown
STP State : Disabled
Link : Down
Accept Frame Types : All
Flow Control : Enable
PortVlanID : 1
PortDefaultPriority : 0
BroadCase StormControl : Disable
Multicast StormControl : Disable
DLF StormControl : Disable
StormControl Percent : 100%
Ingress BandWidth Control : Disable
Egress BandWidth Control Value : 16m
Port Description :
Setting the description of ports
descriptor
example
：
Switch(port(1-1))# descriptor
Port 1 description :abc
Note: this command is DOS prompt type. And will be between 1 and 16 english character.
Open and close the ports
enable or disable
example
：
Switch(port(1-1))# disable
Note: “enable” meaning the ports is open, but “disable” meaning the ports is closed.
Open and close the flow control of the ports
flow control
flow control <seeting enable or disable>
example
：
Switch(port(1-1))# flow control disable
Note: “enable” meaning the flow control of ports is open, but “disable” meaning the flow control of ports is closed.
Setting the working mode of the ports
mode
example
：
Switch(port(1-1))# mode full-100
Note: It’s not the same of setting 100M ports and 1000M ports.
100M ports:
autonegotiate half-10 full-10 half-100 full-100
1000M ports:
autonegotiate half-10 full-10 half-100 full-100 full-1000
Setting the default priority level about 802.1P of the ports
priority
example
：
Switch(port(1-1))# priority 2
