Chicago Dryer Edge MAXX, Instruction Manual

Page: 282 / 288

Index Edge MAXX
I-2
Check (cont)
Spreader Clamp Linear Bearing Assemblies 4-12
Transfer Belts Condition and Tension 4-13
Transfer Clamp Assembly and Grooved Bearings
4-7
Upper and Lower Spreader Belt Condition and
Tension 4-13
Check and Adjust
Transfer Clamp 7-10
Check and Clean
Inverters 4-4
Photosensors and Reflectors 4-4
Check and Grease
Bearings 4-17
Transfer Conveyor Gears 4-19
CHI Panel
About 5-7
Adjustment C-9
End Adjustment C-10
Ironer Speed Interlock Adjustments C-11
Program Adjustments C-12
Start Adjustment C-9
Controls and Indicators 3-7, C-3
Diagnostic Message Index, Troubleshooting 6-6
Function Checkout, Installation 2-18
Operation C-3
Controls and Indicators C-3
Counters C-6
Jam Detection C-6
Model Type/Number of Programs C-4
Program Selection C-4
Safety Stop Buttons C-6
Self-Diagnostics C-6
Speed Control C-5
Programming C-7
End Programming C-8
Make Programming Changes C-8
Start Programming C-7
Testing C-13
24 VAC Outputs C-13
End Testing C-15
Inlet Section C-16
Isolated Transistor/Relay Outputs C-13
Sensor Activation C-18
Spreader Section C-18
Start Testing C-14
Transfer Section C-16
Troubleshooting 6-27
Clean
Air Filter/Auto Drain 4-16
Corner Photosensors, Installation 2-15
Clean and Lubricate
Drive Chain 4-15
Clutch/Brake, Pneumatic
About 5-15
Roller
Alignment 7-7
Alignment Check 4-5
Drive Belt Tension Adjustment 7-8
Communications and the Control Panel, Control
System 5-7
Compressed Air Supply
Checkout 2-15
Connection 2-6
Compressed Air System 7-51
About 5-14
Air Bar
About 5-15
Alignment 7-61
Air Cylinder
About 5-15
Air Flow Adjustment 7-51
Discharge Conveyor 7-53
Inlet Conveyor Lift 7-51
Lower Spreader Belt Push 7-52
Transfer Clamp 7-52
Transfer Rodless 7-52
Mechanical Adjustment
Spreader Clamp 7-17
Transfer Clamp 7-10
Air Cylinder, Rodless
Inspect 4-7
Service 7-55
Increase the Air Cushion 7-58
Tighten the Carriage Block 7-57
Tighten the Drive Blocks 7-56
Tighten the Drive T 7-55
Tighten the Inner Band 7-59
Air Filter/Regulators 5-14
Air Foil Adjustment 7-62
Air Pressure Adjustment, Back
Spreader Clamp 7-54
Air Pressure Switch 5-14
Air Reservoir 5-15
Air Valves/Air Valve Solenoids 5-15
Flow Controls 5-15
Pneumatic Clutch/Brake 5-15
Tail Air Assembly Adjustment 7-63
Troubleshooting 6-28
Controls, Operating.
See
Operating Controls
Controls and Indicators, CHI Panel 3-7, C-3
Control System, Electrical 5-7
CHI Panel 5-7
Communications and the Control Panel 5-7
I/O Control Panel, Electrical Panel 5-8
Photosensors 5-10
Proximity Sensors 5-10
TOC INDEX