Chicago Dryer Edge MAXX, Instruction Manual

Page: 190 / 288

Repair Edge MAXX
7-58
Insert a metric Allen wrench through the
socket (Figure 7-75, B) and tighten the
eccentric cam adjustment bolt.
Tighten the jam nut.
NOTE: Each adjustment bolt
should be adjusted relatively
equally.
Repeat Steps 4 to 6 for the other jam nut/
adjustment bolt.
Manually push the carriage assembly back
and forth to check for excessive friction.
If the assembly is difficult to move, the
adjustment is too tight.
Repeat Steps 4 to 8 until the carriage as-
sembly moves smoothly but not too easily
with no lateral wiggle in the carriage.
Replace the black plastic dust caps re-
moved in Step 3.
Reinstall the index clamp center plate
removed in Step 2.
5.
6.
7.
8.
9.
10.
11.
Increase the Air Cushion
Required Tools
small slotted screwdriver
Perform only when the unit is OFF
with power disconnected.
If the rear air cushion is to be adjusted,
make sure the discharge conveyor is in
the UP position and that the safety latch
is engaged.
Turn power OFF at the main disconnect
switch.
Turn OFF the compressed air supply to
the unit.
Make sure the compressed air system is
depressurized.
Locate the air cushion adjustment screw
at the end of the cylinder near the air inlet
valve (Figure 7-76). If necessary, move
the discharge conveyor ribbons aside for
access
Turn the screw 1/8 to 1/4 turn clockwise
to increase the air cushion.
1.
2.
3.
4.
4.
5.
Figure 7-76: Turn the air cushion adjustment screw
clockwise in small increments.
TOC INDEX