Chicago Dryer Edge MAXX, Instruction Manual

Page: 187 / 288

Edge MAXX Repair
7-55
Inlet Transfer Rodless Air Cylinder
Service
Many of the following procedures will be
performed as a direct result of the weekly
preventive maintenance checks on this device:
Tighten the Drive T
Tighten the Drive Blocks
Tighten the Carriage Block
Increase the Air Cushion
Tighten the Inner Band
CAUTION
The following procedures are
critical to the performance
and service life of the inlet
transfer rodless air cylinder.
Perform these tasks if the
weekly PM checks indicate
the necessity!
•
•
•
•
•
Tighten the Drive T
Required Tools
metric Allen wrench, small slotted
screwdriver, Loctite
®
243 thread lock
Perform only when the unit is OFF
with power disconnected.
If necessary:
Turn power OFF at the main discon-
nect switch.
Turn OFF the compressed air supply
to the unit.
Make sure the compressed air system
is depressurized.
Pull the station’s transfer clamp assem-
bly toward the center of the machine.
Remove the index clamp center plate from
the bottom of the carriage assembly (Fig-
ure 7-70) and place to the side.
Use a small slotted screwdriver to pry the
black plastic dust caps which cover the
drive T mounting bolts (Figure 7-71, A).
These can be discarded.
Remove the mounting bolts and coat the
threads with Loctite
®
243 thread lock.
1.
a)
b)
c)
d)
2.
3.
4.
Figure 7-71: Black plastic dust caps cover the drive
T and carriage block adjustment bolts.
A
B
B
Figure 7-70: The index clamp center plate must be
removed to gain access to the carriage
assembly adjustment bolts.
TOC INDEX