Chicago Dryer Edge MAXX, Instruction Manual

Page: 208 / 288

3024-024e Edge Maxx
C-12
Program Adjustments [PGM
SPECIFIC]
NOTE: These adjustments are
STATION program specific.
These adjustments apply specifically to the
currently running program. If adjustment mode
was entered with FEEDER OFF shown in the
display, changing any of these settings will have
no effect.
These settings can be individually adjusted:
IPACE
MAXLEN
GRAB
AIR
GAP •
•
•
•
•
When [PGM ADJUSTMENTS] is chosen
from the SELECT ADJUSTMENT menu, the
following displays:
IPACE=07/MIN MAXLEN=070”
GRAB=-04 AIR=.16S GAP=3”
Note that the IPACE setting only has meaning
if the unit is equipped with the optional pacing
light.
Refer to the table below for information about
each available function to use as a guide in
making adjustments.
CHI ADJUSTMENTS
Adjustment Function Range
(Increment)
Low Range Select High Range
Select
Standard
Setting
IPACE Sets the feed rate (in
pieces-per-minute) of the
optional pacing lamp. The
same setting applies to both
stations.
6 - 12/MIN
(1)
Green light
indicates constant
target performance.
Flashing red light
indicates constant
below target
performance.
7/MIN
MAXLEN Optimizes spreader speed
based on the maximum
length of the pieces being
processed.
060” - 120”
(1”)
Avoid low settings.
Excessive overlap
could lead to folder
problems.
Unit will operate
below maximum
efficiency.
070”
GRAB Determines when the clutch
brakes stops and the size of
the corners.
-12 - 0
(1)
Corners too large
leading to laydown
problems.
Corners too
short for reliable
transfer clamp
grab.
-6
AIR Blast duration of the laydown
air blast.
.12 - .20 sec.
(.01 sec)
Laydown is erratic. Laydown is
erratic. Low air
pressure.
.12 sec.
GAP Minimum spacing between
items fed. +03” - +06”
(1”)
Overlap leads
to the tail of the
pervious piece
being corrupted.
Unit will operate
below maximum
efficiency.
+00”
TOC INDEX C-TOC