Chicago Dryer Edge MAXX, Instruction Manual

Page: 193 / 288

Edge MAXX Repair
7-61
Air Bar Alignment
There are two air bars used to lay down the
leading edge of the flatwork. The two air bars
should always point horizontally, with the air
blast blowing between the discharge ribbons and
the air foil.
The air bars may require adjustment when the
lay down of the fabric is erratic.
Required Tools
Allen wrench
Perform only when the unit is OFF
with power disconnected.
Turn power OFF at the main disconnect
switch.
The adjustment point is located slightly
above and in front of the discharge drive
roll at the center of the unit. Access the ad-
justment point from the front of the unit.
Before making any adjustments, mark the
original air bar position for reference.
Loosen the setscrews at both ends securing
the air blast bar (Figure 7-82).
Align the rows of air manifold holes hori-
zontally across the left and right bars. The
holes on both bars should be blowing at
the same level.
Tighten all setscrews.
Start the unit and process several pieces
to test the adjustment.
1.
2.
3.
4.
5.
6.
7.
Figure 7-82: Lower air bar setscrew location.
TOC INDEX