Chicago Dryer Edge MAXX, Instruction Manual

Page: 200 / 288

3024-024e Edge Maxx
C-4
Model Type/Number of Programs
When the unit first starts up, the following
displays on the CHI Panel for about 3 seconds:
CHICAGO EDGE
TYPE XX XX PROGRAMS
Type
The 2-digit type code indicates whether the
machine has a standard or extra-long inlet “nose”
and whether the machine will use standard or
metric measure as shown in the table below:
Type Meaning
00 Standard Nose/Standard Measure
01 Long Nose/Standard Measure
02 Standard Nose/Metric Measure
03 Long Nose/Metric Metric
If you are not sure whether the type code
displayed is correct for your machine, contact
the Factory Service Department.
Programs
The unit can internally maintain up to 32
program settings, although it would be rare for
any operation to require that many. The machine
ships from the factory set for 4 programs. To
change the number of available programs in
increments of 4:
Within the first 3 seconds of display, press
the CURSOR so that it is under the number
of programs.
Immediately press the + or – button to
set the desired number of available pro-
grams.
1.
2.
Program Selection
Once the standard display shows, pressing
a STATION button will select the program(s)
entered for that particular station button. If the
unit has 8, 16, or 32 programs, pressing the
STATION button repeatedly will cycle through
the programs assigned to that button.
Pressing a STATION button until the light
goes off leaves the machine running in standby
mode.
FEEDER OFF
Any flatwork fed into the machine in this point
will simply be pulled through the inlet belts and
dropped on the floor.
TOC INDEX C-TOC