Chicago Dryer Edge MAXX, Instruction Manual

Page: 203 / 288

Edge Maxx 3024-024e
C-7
II. PROGRAMMING
The spreader/feeder is programmed at the factory
for common piece sizes with typical values for item
names, conveyor speed, bypass and CHI select.
Since each laundry is different, the unit can be
reprogrammed as desired. This is done by using
the CD button to enter programming mode as
explained below.
In addition to programming changes, two types of
adjustments can also be made. One is specific to the
currently running program while the other is global
for all machine activity. For more information, refer
to the
Adjustment
section.
NOTE: In order to eliminate
accidental changes, only qualified
supervisors should have access
to the programming section of the
CHI control panel.
WARNING
Never touch any part of the
machine while it is running.
Serious injury could result.
Only trained repair personnel
should work on the unit.
Always think carefully
around moving machinery.
NOTE: Work with another
person. The “buddy system” is
the safest system.
Start Programming
To program any of the CHI Panel’s function,
follow these steps:
NOTE: One of the station
buttons must be selected in order
to enter program mode.
Press the appropriate STATION button
until the desired program displays.
Press and hold the CD button; then, press
the ENTER button. Release both buttons.
The CHI Panel shifts into programming
mode with the flashing cursor under the
FPM setting:
02 KING SHEET COTTON
CHI=0 O84FPM BYP=0
NOTE: To change a different
program, press the appropriate
STATION button. The number in
the upper left corner of the display
will change accordingly.
1.
2.
TOC INDEX C-TOC