Chevrolet Spark Lite, Owner'S Handbook Manual

Page: 209 / 265

Service and Maintenance
. . . 208
Side Turn Signal Lights
(If equipped)
1. Pull the light assembly rear-
ward and remove it.
2. Turn the bulb socket counter-
clockwise.
3. Pull the bulb straight out to
remove it from the socket.
4. Reverse the steps to install a
new bulb.
Make sure to push the light as-
sembly back to its original po-
sition.
Taillights, Stoplights and Rear
Turn Signals
1. Open the rear hatch.
2. Remove two screws from the
light assembly.
3. Remove the light assembly.
4. Turn the bulb socket counter-
clockwise to remove it.
5. Gently push in and turn the
bulb counterclockwise to
remove it from the socket.
6. Reverse the steps to install a
new bulb.
Center High-Mounted Stoplight
(If equipped)
1. Open the rear hatch.
2. Remove two screws from the
light assembly.
3. Disconnect the wiring harness
connector before removing
the light housing.
4. Remove the light housing.
5. Remove the two screws and
remove the reflector assembly.
6. Pull the bulb straight out to
remove it from the socket.
7. Reverse the steps to install a
new bulb.
09Spark_GenR.fm Page 208 Monday, May 5, 2008 2:03 PM
209 . . .
–
–
–
–
Section 4
Rear Fog Light (If equipped) or
Backup Light
1. Reach in behind the rear
bumper and disconnect the
wiring harness connector.
2. Turn the bulb socket counter-
clockwise.
3. Remove the bulb from the
socket.
4. Reverse the steps to install a
new bulb.
License Light
1. Remove the two screws and
the light cover.
2. Turn the bulb socket counter-
clockwise to remove it.
3. Pull the bulb out of the socket.
4. Reverse the steps to install a
new bulb.
Dome Light
1. Use the flat edge of a screw-
driver to pry the lens away
from the headliner.
2. Remove the bulb.
3. Reverse the steps to install a
new bulb.
09Spark_GenR.fm Page 209 Monday, May 5, 2008 2:03 PM