Chevrolet Spark Lite, Owner'S Handbook Manual

Page: 43 / 265

Instrumentation and Controls
. . . 42
Rotate the band to OFF to turn off
all the lights.
Rotate the band to
to turn on
your parking and other operating
lights. The headlights will not
come on.
Rotate the band to
to turn on
your headlights. The parking and
other operating lights will also
come on.
If you turn the ignition to
LOCK or
ACC (accessory), the headlights
will turn off automatically.
Instrument Light Dimmer
The instrument light dimmer
controls the brightness of the
instrument panel lights.
The control is located on the
instrument panel, next to the light
switch.
Rotate the dial up to increase
brightness and down to decrease
brightness.
Daytime Running Lights
(If Equipped)
This feature makes your daytime
running lights automatically turn
on during the day so that it is
easier for others to see the front of
your vehicle.
The parking lights and headlights
must be off for this feature to
work.
The engine must be running.
09Spark_GenR.fm Page 42 Tuesday, April 29, 2008 10:03 AM
43 . . .
–
Section 1
Turn Signal
To signal a turn, move the lever all
the way up (right) or down (left).
When the turn is over, the lever
will return automatically. To signal
a lane change, just raise or lower
the lever until the arrow starts to
flash. Hold it there until you
complete your lane change.
An arrow on the Indicator and
Warning Lights Display will flash in
the direction of the turn or lane
change.
If the arrows don't flash, check for
burned out indicator bulbs and
check the fuse.
CAUTION
These indicators are required
for safe driving.
Immediately replace any
burned out indicator bulbs.
Failure to keep the indicators in
proper working condition can
cause a collision resulting in
personal injuries and damage to
the vehicle or other property.
Shorter than usual flashes of the
indicator lights mean that exterior
turn signal bulbs may be burned
out.
If a bulb is burned out, replace it to
help avoid an accident.
High-Low Beam Control
The low beam headlights must be
on in order for this feature to work.
Push the lever toward the front of
the vehicle to turn on the high
beams.
When the high beams are on, the
High Beam Indicator light will also
be on.
09Spark_GenR.fm Page 43 Monday, May 5, 2008 2:03 PM