Chery TIGGO, Owner'S Manual, Page: 85 / 154

Driving
84
For parking after long-time traveling at high speed,
don’t stop the engine immediately; let the engine
operate for another 2 minutes at the speed higher
than idle speed, in order to make the temperature
decrease gradually.
Brake
Dual-Circuit Brake System
Your vehicle is equipped with X-type dual-circuit
system. If one of the circuits does not work, the
other can still operate well.
Brake Fluid
If the brake system warning light is not off after
releasing the hand brake, it means the brake fluid
level is low or other failures.
Please check the level of brake fluid according to
requirement and check the failures.
Introduction to Brake System
It is normal that the brake system makes a noise
sometimes. But if it has made noises of metal
grinding or screeches for a long time, it indicates
the brake lining may be seriously worn and needs
to be replaced. Here the vehicle shall be sent to
Chery authorized service station for overhaul.
If there is continuous jitter or vibration passing to
the steering wheel when braking, the vehicle shall
be sent to Chery authorized service station for
overhaul.
The new friction lining of brake has to be run in to
get the best braking effect. The braking effect may
reduce a little in the first 200km, in this situation;
only stepping on the pedal with a greater force can
retrieve the braking efficiency. This point is also
applicable for the newly-replaced brake lining.
After the ignition switch is turned off
to stop the engine, if the engine temperature
is still high, the electronic cooling fan of
radiator will continue to operate about 10
minutes. Even though the cooling fan stops
operation, it may operate again because of
the high temperature. Therefore, you have to
be cautious when working beside the engine.
The brake fluid shall be added
immediately to the Max level and the vehicle
shall be sent to Chery authorized service
station to check the brake system.
When one of the circuits does not
work, it is necessary to step on the brake
pedal with great force, and the stopping
distance becomes longer. If this situation
occurs, please send the vehicle to Chery
authorized service station for overhaul before
your travel.
Don’t step on the accelerator pedal
before stopping the engine.