
Emergency Procedure
110
Removing Wheel
1. Make sure the front wheels point to the front.
2. Turn off the ignition switch.
3. If the vehicle is equipped with the automatic
transmission, please set it to position P.
4. Ask the passengers to get off the vehicle.
5. If necessary, use a proper wheel block stop to
secure the vehicle and prevent it from rolling or
sliding.
6. Insert the slotted screwdriver between wheel rim
and wheel hub cover, and then rotate it carefully to
remove the wheel hub cover.
7. Use special tools on the vehicle to loosen the
wheel bolts as shown in the following figure.
8.
Place the jack so that the whole foot seat
surface is located on a firm ground.
9.
The jack shall be jacked up vertically to the
jack-up point.
10.
Jack up the vehicle until the wheel is above the
ground.
11.
Loosen the wheel bolts to remove the wheel.
Install Wheel
1. Push the wheel onto wheel hub bolts. Screw
the wheel nuts clockwise and ensure the
wheel nuts sharp end shall face towards the
wheel.
2. Lower the vehicle to remove the jack.
3. Tighten the wheel nuts in diagonal sequence.
4. Press into the wheel hub cap by hands
carefully.
5. Take away the jack and the faulty wheel in
reverse order, and tighten them.
6. If possible, deliver the wheel to Chery
authorized service station to check the
tightening torque of the wheel bolt and the tyre
pressure.
Battery
Your vehicle is equipped with the 12V and 60A
maintenance-free lead-acid battery.
Safety Advices
The acid liquid of the battery is corrosive. Be sure
to wear gloves and goggles. Do not allow your skin
or clothing to come in contact with acid or lead. Do
not tilt the battery, for the acid liquid may flow from
the vent opening. If the acid liquid splashes into
your eyes, wash your eyes immediately with clean
water for several minutes and then seek doctor’s
advice. If the acid liquid splashes onto your skin or
clothing, neutralize it with alkaline water (soap) and
then wash your skin or clothing with clean water. If
the acid liquid is swallowed, rush to the hospital
immediately.
While handling the battery, make sure
to take the following precaution measures.
Summary of Contents for TIGGO
