Chery TIGGO, Owner'S Manual, Page: 120 / 154

Maintenance
119
The brake fluid and clutch oil is supplied by the
same reservoir.
The fluid level should stay between MAX and MIN
marks at the side of reservoir. If the fluid level
drops to the MIN mark, the low brake fluid level
warning light will light up.
Please add Chery special brake fluid. See the
chapter “Capacity and Specification” and send
your car to Chery authorized service station to
check system leakage.
It is important to ensure the absolute cleanness in
case of adding the brake fluid.
The symbol behind brake fluid reservoir means
using non-paraffin brake fluid.
Engine Coolant Tank
Do not open the filling cover in the event of a
running engine or the high temperature.
Inspect the coolant level through the translucent
reservoir. When the engine is in the cold state, the
coolant level should be between MIN and MAX
marks. The coolant level may exceed the MAX
mark when engine is hot. The coolant can be
added when engine is cold; if it is needed to add
the coolant when engine is hot, first of all, wait 10
minutes to let the engine cool down. Unscrew the
cover of reservoir for a quart of circle to discharge
the pressure. Wait for a period of time and then
open the cover fully. Add the coolant with mixture
of 50% water and 50% coolant.
Engine Coolant
Using the coolant with correct concentration will
not only protect the engine from freeze in the
winter, but also provide the anticorrosion
protection throughout the year. Modern engines
operate at the extremely high temperature, so the
bad coolant cannot provide the proper
anticorrosion protection for the cooling system. So,
please add the coolant in line with the specification
of Chery. Please refer to the chapter of “Capacity
and Specification Parameters” for capacity.
Do not mix the coolants together of
different colors and specifications
Do not let the brake fluid contact your
skin or eyes. Providing such occasion is
encountered, please clean the affected parts
with plenty of water and immediately seek the
medical treatment.
When adding the coolant, be careful
to avoid splash it onto any part of engine.
Change the brake fluid after the
driving of each 2 years or 40000KM.
Do not let the brake fluid contact paint. If the
fluid touches the paint surface, please wipe
out the fluid with the wet sponge or rinse the
paint surface with plenty of water.