Chery TIGGO, Owner'S Manual, Page: 54 / 154

Light Control
53
Front Doorsill Lamp and Key Hole
Luminous Lamp
When left front door is opened, the key hole
luminous lamp will be on.
The front doorsill lamp is installed into two front
door inner trim panel; Regardless if ignition switch
is turned on, the doorsill lamp will be on if door is
opened. The doorsill lamp will light up foot area to
guide driver and will go off automatically after
closing the door.
The key hole luminous lamp is installed around the
ignition switch. This lamp will be on once opening
the left front door to help driver inserting ignition
key. The lamp will go off when key is switched to
position “ON”.
Hazard Warning Lamp Switch
Daytime lamp
The hazard warning switch is only for use under
emergence; it can warn the following vehicles of a
failure or a dangerous condition. Pressing this
switch down can turn on or turn off the hazard
warning system. The hazard warning light can still
work even if ignition switch is turned off.
After the warning light is turned on, the indicator
light on the switch will flash. At the same time, turn
signal indicator lights on the combination
instrument will also light.
Daytime Lamp
When engine is running normally, the high beam
and fog lamp is turned off and release the hand
brake; then daytime lamp will be on and daytime
lamp symbol is lit on instrument panel.
If the high beam and fog lamp is turned on, the
daytime lamp will be turned off automatically. But
the lamp will not go off if using the turn signal lamp
for short time.
Note: Following operations may cause the
initial memory lost of sunroof module
1. During vehicle maintenance, replace the
battery or disconnect the power when
sunroof is not at initial position.
2. Disconnect module power during sunroof
operation.
3. When sunroof controller can not return to
normal position.
4. Other causes that leads the lost of
module initial memory.