
Maintenance
122
The worn depth of tread is limited in relevant laws
and regulations. Notice that: when the worn depth
reaches the limiting value of 3mm, the worn areas
will appear on the tread, which indicate that the
performance and security of tyre has greatly
degraded and the tyre must be replaced.
Replacement of Tyre
The tyres used by your vehicle are specially
chosen to provide the best vehicle control, comfort
and safety. The above-mentioned combined
provisions of tyre and rim are applicable to the
steel or aluminum alloy wheel rim. If you want to
know whether other types of tyre and rim can be
used in the vehicle, please consult the authorized
service station of Chery.
It is strongly advised that you use the genuine
tyres or refer to the authorized service station of
Chery when installing the tyres.
Note:
The speedometer is affected by the size of
tyres used for the vehicle. If the tyre size
(diameter) is different from the original one, the
correct speed will not be shown.
Anti-skid Chain for Snowy Ground
The anti-skid chains for snowy ground can be used
for summer and winter tyres, but are only
applicable to the driving wheels (i.e. front wheels).
When the anti-skid chains for snowy ground are in use, the
traveling performance of vehicle equipped with the anti-skid
control system may have some anomalies which can be
eliminate by shutting down this system.
To avoid the damage of wheel cover, please remove the
cover firstly before mounting anti-skid chain. And
remember to mount it back at once after removing the
anti-skid chain.
If you want to install the non-standard tyre
or rim, (such as the light alloy rim or wheel of winter
tyre); surely you should comply with the instructions
or consult the authorized service station of Chery.
The unsuitable tyres and rims may lead to
an accident, which are not within the scope of
warranty.
1. When using the anti-skid chains, be sure
that the vehicle speed shall not exceed 50 km/hour.
2. The anti-skid chains should be removed
immediately in the absence of snow on the road.
It is suggested to check and adjust the four
wheels alignment in vehicle first maintenance and
then make inspection and adjustment on every
20,000Km.
The worn tyres should be treated under
local environmental protection provisions. Once the
road conditions allow, the winter tyres should be
immediately changed with summer ones. This will
reduce the fuel consumption and the noise.
Regularly interchange the tyres. It is recommended
to interchange four wheels for every 10,000 km.
(the best tyres interchange mileage is
5000-7000Km) interchange left front tyre with the
right rear tyre, and interchange the right front tyre
with the left rear tyre.
Summary of Contents for TIGGO
