1 Operational Manual
2.10 Air –Blow Setup
AIRBLOW SETTING
????.?
mm
AIRBLOW DURING OPENING MODE : Ａ
AIRBLOW AT OPENING POSITION : TTT.Tmm
AIRBLOW TIME SETTING : UUU.USEC
AIRBLOW AT MOLD OPENED MODE : Ｂ
PAUSE TIME AFTER MOLD OPENED : VVV.VSEC
AIRBLOW TIME SETTING : WWW.WSEC
F1
F2
F3
F4
F5
F6
F7
F8
F9
F10
Menu 8
2.10.1 Move cursors to set parameter for air-blow. Key in desired digits and press
to
complete a correction. Code descriptions for air-blow Menu (08) are shown below:
A) Ａ :Function selection for air-blow during mold opening. Press
to open and
to close.
B) TTT.T: Position setup. Air-blow during mold-open will start functioning at this
position.
C) UUU.U: Time setup for air-blow during mold-open. Code is
“
Tim 25
”
。
D) Ｂ :Function selection for air-blow after mold-opening. Press
to open
and
to close.
E) VVV.V: Intermission setup for air-blow after mold
–
open. Code is
“
Tim 26
”
.
04/08/13
48
