CDC-2000
操作手冊
Operational Manual
04/08/13
47
L) MMM.M : Time setup for Mold Screw out/slow, program timer code
“
Tim 17
”
。
M) NNNNNN : Feedback options for Mold Screw-out. Press either
or
to
make a pick among three molds, and push
to complete the selection. Code
descriptions for function selection as follows:
M.a) Select
“
Timer
”
to confirm the completion of Mold Screw out. Time for unscrew-
out/fast is set at
“
JJJ.J
”
, then Mold Screw out/slow is set at
“
MMM.M
”
.
M.b) Select
“
limit switch
“
as spare function selection.
M.c) Select
“
counter
“
as a confirmation by Mold Screw turns.
“
GGGGG
”
Total turns for
mold screw in and out.
“
EEEEE
”
Mold Screw fast-turn counts, internal program
code
Cnt 5.
“
FFFFF
”
Mold Screw slow-turn counts, internal program code
Cnt 6
.
Counting signal is keyed in to
Input 30
。
2.9.2.
Mold Screw Out Setup
Move cursor to set parameter of Mold Screw out 3. Key in desired digits and press
to
complete a correction. Code descriptions of Menu (07) as follows:
A) OO :Speed setup for Mold Screw out/fast.
B) PP : Pressure setup for Mold Screw out/fast.
C) RR : Speed setup for Mold Screw out/slow.
D) SS : Pressure setup for Mold Screw out/slow.
E) CCCCCCCCCC :Mode options for Mold Screw out. Press either
or
for one
of four modes listed below, and push
to complete the selection. Code
descriptions for function selection are as follows:
E.a) Mold Screw-out Off.
E.b) Before mold-closing: Mold Screw out before closing molds.
E.c) During mold-closing: Mold Screw out during mold closing at
“
DDDD.D
”
set
position.
E.d) After mold-closing: Mold Screw out after mold close.
F) DDDD.D : Mold Screw out when molds close at this position.
G) QQQ.Q : Time setup for Mold Screw out/fast, program timer code
“
Tim 18
”
.
H) TTT.T : Time setup for Mold Screw out/slow, program timer code
“
Tim 19
”
.
I) UUUUUU :Feedback options for Mold Screw out. Press either
or
to make
a pick among three molds, and push
to complete the selection. Code
descriptions for function selection are as below:
I.a) Select
“
Timer
”
to confirm the completion of Mold Screw out. Time for Mold Screw
out/fast is set at
“
QQQ.Q
”
, and then Mold Screw out/slow is set at
“
TTT.T
”
.
I .b) Select “Limit Switch” as spare function selection.
