Case 580ST, Operator'S Manual

Page: 64 / 434

3 - CONTROLS AND INSTRUMENTS
Exiting the machine:
1. Canopy machines proceed to Step 4.
2. Pull the handle (1) downward to open the door from
the inside.
3. Fully open the door.
4. Use the steps and grab handles when exiting the op-
erator’s compartment. Always maintain three points of
contact with the machine steps and grab handles.
5. Maintain a secure grip and solid footing until you are
standing on the ground.
6. If applicable, close and lock the door.
NOTE: Use the starter switch key to lock the doors.
RCPH10TLB333AAF
3
Cab door window and side window operation
NOTICE: Do not allow the windows to swing freely, always
secure the window position.
NOTICE: When opening or closing windows, always hold
them firmly until they are completely locked in position.
Hold partially open:
Raise the handle (1) and push it outwards and down-
wards to lock the window in a partially opened position.
Hold fully open:
1. The window must be in the closed position, raise the
handle (1) to the horizontal position and then tilt it rear-
wards to disengage it from the pin.
2. Open the window until it engages in the rubber locking
device (2) . Make sure that the window is secure.
Close and lock the window:
1. Pull knob (3) to disengage the window from the rubber
locking device (2)
2. Close the window and make sure that the window han-
dle (1) completely engages in the lock pin.
3. Push the window handle (1) downwards to secure the
window.
LEEN11T0060AA
4
LEEN11T0061AA
5
3-2