Case 580ST, Operator'S Manual

Page: 301 / 434

7 - MAINTENANCE
Power shuttle transmission - Screen filter cleaning
1. Move the machine to a level and firm ground.
2. Raise the loader attachment and install the safety sup-
port strut.
3. Place the backhoe attachment in the road travel posi-
tion.
4. Place the direction-of-travel lever and gearshift lever in
neutral position.
5. Immobilize the machine with the parking brake.
6. Stop the engine and remove the starter switch key.
7. Open and raise the engine guard.
LEEN11T0354AA
1
8. Place a container with suitable capacity under the
screen filter.
9. Clean the area around the cover plate (2) .
10. Loosen and remove the screws (1) .
11. Remove the cover plate (2) , check the conditions of
the O-ring (3) and replace it, if necessary.
12. Remove the screen filter (4) .
13. Clean the filter with a detergent solution.
NOTICE: Follow the instructions for the detergent solution.
CAUTION
Flying debris!
Compressed air can propel dirt, rust, etc. into
the air. Wear eye and face protection when us-
ing compressed air.
Failure to comply could result in minor or mod-
erate injury.
C0049A
Carefully dry the screen filter (4) with compressed air
and reinstall it.
14. Reinstall the cover plate (2) and fasten it with the
screws (1) . Tighten the screws to a torque of 23 N·m
( 16.96 lb ft ).
LEEN11T0406AA_2
2
15. Remove the dipstick (5) and top up the oil through the
dipstick hole. Then restore the dipstick (5) into place.
16. Check the oil level with the dipstick and, if necessary,
add more oil.
17. Lower and lock the engine guard.
18. Remove the safety support strut and lower the loader
attachment.
RAIL15TLB0174AA
3
7-79