Case 580ST, Operator'S Manual

Page: 194 / 434

6 - WORKING OPERATIONS
Loader bucket with forks (Optional)
WARNING
Avoid injury and/or machine damage!
When not in use, securely retain the forks in their proper storage position with the pins and split pins.
Failure to comply could result in death or serious injury.
W1330A
NOTICE: The forks are heavy, so use great care when swinging them into their working and stowage position.
Install forks in working position
1. Move the bucket to a level and firm ground.
2. Stop the engine and remove the starter switch key.
3. Raise the parking brake lever.
4. Remove the retained pin and the pin (1) .
5. Lower the fork (2) manually and carefully until it is lay-
ing in position against the bucket cutting edge.
NOTICE: The forks must be laying against the cutting
edge of the bucket, and never against bucket teeth.
LEEN11T0167AA
1
1. Install the pin (1) and the safety pin.
2. Repeat the same operations for the other fork.
3. Slide the forks until they are suitably spaced for the
intended job.
NOTICE: The two forks must be positioned at the same
distance from the centre of the bucket.
NOTICE: Never use the forks to lift the machine.
NOTICE: When using the forks with a 4x1 bucket, never
attempt to use the bucket jaw opening function.
LEEN11T0168AA
2
Install the forks in rest position
1. Rest the loader bucket on a level and firm ground.
2. Stop the engine and remove the starter switch key.
3. Disengage the parking brake lever.
4. Remove the retained pin and the pin (1) .
5. Tilt the fork (2) manually and carefully until it is rear-
wards into transport position.
LEEN11T0169AA
3
6-16