Case 580ST, Operator'S Manual

Page: 121 / 434

3 - CONTROLS AND INSTRUMENTS
Backhoe attachment mechanical controls version
WARNING
Unexpected machine movement!
Before you use the backhoe attachment, make sure that the machine is resting on the stabilizers.
Failure to comply could result in death or serious injury.
W1326A
Stabilizer mechanical controls
Left-hand stabilizer left-hand control lever
This lever has three positions:
Position 0: Neutral. This position stops the movement of
the left-hand stabilizer. As soon as the lever is released,
it automatically returns to the neutral position 0 and the
left-hand stabilizer stops raising or lowering.
Position 1: The left-hand stabilizer lowers.
Position 2: The left-hand stabilizer rises.
Right-hand stabilizer right-hand control
lever
This lever has three positions:
Position 0: Neutral. This position stops the movement of
the right-hand stabilizer. As soon as the lever is released,
it automatically returns to the neutral position 0 and the
right-hand stabilizer stops raising or lowering.
Position 1: The right-hand stabilizer lowers.
Position 2: The right-hand stabilizer rises.
NOTE: To raise or lower the two stabilizers at the same
time, operate the two levers simultaneously.
NOTICE: Before machine travel or before using the
loader attachment, make sure the stabilizers are com-
pletely raised.
During road travel, the stabilizers must be completely
raised and immobilized with the pins provided for that
purpose.
LEEN11T0312AA
1
Locking the stabilizer mechanical controls
(specific to certain countries)
The pin (1) located in front of the stabilizer control levers,
is used to lock the stabilizer controls.
To lock the controls, remove the pin from its housing and
install it in the specially provided hole in the console.
NOTICE: Before leaving the operator’s compartment, un-
dertaking any road travel or working with the backhoe at-
tachment, place the pin in locking position.
LEEN11T0313AA
2
3-59