Case 580ST, Operator'S Manual

Page: 289 / 434

7 - MAINTENANCE
Engine oil filter - Replacement
1. Move the machine to a level and firm ground.
2. Raise the loader attachment and install the safety sup-
port strut.
3. Place the backhoe attachment in the road travel posi-
tion.
4. Place the direction-of-travel lever and gearshift lever in
neutral position.
5. Immobilize the machine with the parking brake.
6. Stop the engine and remove the starter switch key.
7. Open and raise the engine guard.
8. Place a container with suitable capacity under the filter.
LEEN11T0354AA
4
9. Unscrew and remove the cartridge (1) with the wrench
380000670 .
NOTICE: The oil filter contains an oil quantity of approxi-
mately 0.5 L ( 0.15 US gal )
10. Apply a thin layer of clean oil on the seal of the new
cartridge.
NOTE: Do not fill the new filter with oil before installing it.
11. Assemble the new cartridge (1) .
12. Manually screw in the cartridge until the seal touches
the support (2) .
13. By means of wrench 380000670 , tighten by 3/4 of a
turn.
NOTICE: Overtightening can damage the filter seal.
14. Let the motor run for several minutes and then check
the level again by means of the dipstick.
15. If necessary, top up to compensate the quantity of oil
used for filling the cartridge.
16. Lower and lock the engine guard.
17. Remove the safety support strut and lower the loader
attachment.
LEEN11T0414BA_1
5
Oil specification and capacity
Use CASE AKCELA UNITEK 10W-40 Engine oil SAE
10W40 , MAT3521 engine oil or an oil meeting the fol-
lowing specification:
•
API CH-4
•
ACEA E5
NOTE: A higher quality oil is accepted.
Engine oil capacity (with filter): 11.70 L ( 3.09 US gal )
7-67