Advanced Million Color Mini Motorcycle Lighting Kit
Warning:
Please check your state and local laws before installing this Motorcycle Lighting Kit. Every state has different policies
and procedures in place regarding aftermarket LED lighting accessories. LEDGlow is not responsible for any fines that you may
receive while using this lighting kit.
This kit is for off road use only.
Warning:
The installation of this kit is recommended to be installed by a licensed professional. The improper installation of this
kit will void all warranties.
PLEASE READ THE FOLLOWING INSTRUCTIONS THOROUGHLY BEFORE INSTALLING AND OPERATING
THIS LED MOTORCYCLE KIT.
Motorcycle Lighting Kit Includes:
4” Motorcycle LED Lighting
Strips
(1) Control Box
(1) Wireless Remote
Zip Ties
(1) 6pc Power Harness
Motorcycle Kit Installation:
1.
Upon receiving your new motorcycle lighting kit,
we ask that you first test the kit to ensure it is
functioning properly. Connect the red power wire
to the positive terminal of the battery and the black
ground wire to the negative terminal of the battery.
Once the wires are temporarily secure, power the
kit by connecting each light strip to the 6pc power
harness and the harness to the control box to ensure
full functionality before installing it. If everything
appears to be working correctly, turn the kit off
and disconnect the power and ground wires from
the battery to prepare for installation.
2.
Optional
: Remove any trim pieces from your
motorcycle that may hinder the installation of the lighting strips.
3.
Begin by first laying out the LED lighting strips similar to the way they will be installed. Make sure that the wires will
be able to be routed in such a way that they will not be pinched, cut or come in contact with direct heat sources. Be sure
to keep the wires and strips away from all moving parts.
If a power wire is pinched or damaged in any other way, it
will cause the kit to malfunction and will void the warranty due to physical damage.
4.
Temporarily place the motorcycle lighting strips in their intended mounting locations and route the power wires to the
planned control box mounting area.
Be sure to keep the power wires away from the suspension, any direct heat
sources and/or moving parts.
A few recommended locations on your motorcycle to mount the light strips are under
the gas tank, lower frame rail, rear fender frame rail, triple trees, lower swing arm, and under the seat.
5.
Once the motorcycle lighting strips and wires have been mocked up, clean the proposed mounting surfaces with an
alcohol prep pad.
Note:
The surface area must be free of all oils, moisture, dirt, and wax in order for the supplied
adhesive tape to bond and adhere to the installation surface correctly.
Optional:
Use 3M Adhesion Promoter to install
each motorcycle lighting strip to create a much stronger bond between the light strip and the cleaned mounting surface
of your motorcycle. This is an optional installation accessory and is NOT included with your motorcycle lighting kit.
6.
Mount each lighting strip to the clean and dry surface of the motorcycle by using the supplied 3M tape. Run the wires
to the planned location of the control box and secure any loose wires to the bike frame using the included zip ties. Once
this step is complete and the lighting strips and wires are secure, allow ample time for the adhesive to settle and cure.
Repeat this step for the remaining strips included with your kit.
