Carlton 1712, Owner'S Manual

Page: 151 / 165

How to activate and de-activate the “auto-feed” function
The device has a further programming phase, meant for activating and de-activating
the “auto-feed” function. This function includes the emergency procedures previously
described.
NOTE: when the “auto-feed” function is de-activated, the monitor features
exclusively revolution counter function and hours counter function; the reverse
solenoid valve EVR is always de-energized and the EVS safety valve can be de-
energized (if “type 0” operation type is selected) or energized (if “type 1” operation
type is selected). The monitor is supplied as a standard with the “auto-feed” function
enabled; in fact, when the monitor is switched-on with engine off (RPM =0), the ref.
indicator "d" picture "A" pag. 7 is on.
Press key (-) minus for at least 3 seconds to de-activate the “auto-feed” function and
until the sequence below is displayed:
Auto-Feed Reverse
RPM
h
Auto-Feed Reverse
RPM
h
0.5 sec
Auto-Feed Reverse
RPM
h
0.5 sec 0.5 sec
Once the sequence has been completed, engine RPMs are displayed but the ref.
indicator "d" picture "A" page 7 is off; to activate again the “auto-feed” function
press key (+) plus for at least 3 seconds until the sequence below is displayed:
Auto-Feed Reverse
RPM
h
Auto-Feed Reverse
RPM
h
Auto-Feed Reverse
RPM
h
0.5 sec 0.5 sec 0.5 sec
Once the sequence has been completed, engine RPMs are displayed and the ref.
indicator "d" picture "A" page 7 is on.