Carlton 1712, Owner'S Manual

Page: 104 / 165

12” CHIPPER SERVICE
CUTTER SYSTEM
78
•
Use the handle on the anvil to rotate the
anvil 90
°
and pull it through the slot.
•
Remove the handle from the anvil and
turn the anvil to a good working edge.
The working edge that was being used is
on the back opposite side from the
handle.
•
Replace the handle either in the same
hole on the other side of the anvil or
remove the setscrew and insert the
handle in the hole on the opposite side of
the anvil. Use LocTite
®
Red 262 on the
handle when replacing and torque jam
nut to 25 ft. lbs. (5/16”-18 bolt).
•
A setscrew must always be in the hole
next to the working edge to keep debris
out of the hole (see picture at right).
Insert the setscrew on the handle side of
the anvil to prevent clogging the wrench
slot. Use LocTite
®
Red 262 on the
setscrew when replacing to keep the
setscrew from working out of hole or
damage will occur because of tight
tolerances.
•
Replace with a new anvil if all working
edges are worn or damaged. Do not
grind the anvil to get more life. There is
only a certain amount of adjustment
available for clearance and if the anvil is
ground you will loose that adjustment
capability.
•
The anvil is hardened steel made to
Carton’s specifications. Use only
Carlton anvils as replacements or
damage may occur. Purchase the new
anvil from Carlton or an authorized
dealer.
CURRENT WORKING EDGE
HANDLE
INSERT SETSCREW FROM THIS SIDE –
OPPOSITE TO HANDLE
USE LOCTITE
®
RED 262
REMOVE ANVIL –
ROTATE 90
°
&
PULL THROUGH
OPENING