Carlton 1712, Owner'S Manual

Page: 37 / 165

12” CHIPPER DAILY CHECKLIST
11
•
Make sure all personnel are equipped with
all applicable safety equipment:
−
Eye protection
−
Hearing protection
−
Hard hat
−
Short, fitted gloves
−
Long sleeve shirt
−
Long pants
−
Over the ankle work boots with skid
resistant soles
•
Inspect bolts, hydraulic fittings, wiring
harnesses, hoses, and equipment for
tightness, wear, or leakage. Replace if
necessary. DO NOT inspect for hydraulic
leaks with your hand or finger
•
FLUID UNDER PRESSURE CAN
PENETRATE THE SKIN AND CAUSE
SEVERE INJURY. CHECK FOR LEAKS
USING A BOARD OR CARDBOARD;
DO NOT USE HAND OR FINGER.
SEEK IMMEDIATE MEDICAL
ATTENTION IF SKIN IS
PENETRATED. ALWAYS WEAR EYE
PROTECTION.
BECAUSE OF MACHINE VIBRATION,
ALL EQUIPMENT ATTACHED USING
SCREWS OR BOLTS AND NUTS
SHOULD BE CHECKED REGULARLY
FOR TIGHTNESS. ALL SCREWS,
BOLTS, AND NUTS NEED TO BE
INSPECTED FOR TIGHTNESS AND
WEAR. ALL SCREWS, BOLTS, AND
NUTS THAT WON’T STAY TIGHTENED
OR THAT HAVE WORN, CHIPPED, OR
MISSING THREADS SHOULD BE
REPLACED.
PERSONAL PROTECTION:
All personnel must wear eye and
ear protection, hard hat, short
fitted gloves without cuffs, long
sleeve shirt, long pants without
cuffs, and over the ankle work
boots with skid resistant soles
Do not wear loose-fitting clothing
Tie long hair back
Do not wear jewelry or long
dangling clothing; i.e. neckties,
long belts, or chains
Stay away from cutter disk
Keep away from moving parts
Only run in a well ventilated area
because of carbon monoxide
poisoning